2/28 Lauretta Street

Newton SA 5074

Give us a Call

(08) 7230 6373

2/28 Lauretta Street

Newton SA 5074

Give us a Call

(08) 7230 6373

Customer Enquiry

Workshop

MINOR SERVICE - $350

  • Replace engine oil and filter
  • Replace primary oil
  • Inspect air cleaner, service as required
  • Check rear belt adjustment & alignment
  • Inspect transmission lubricant
  • Inspect primary chain adjustment
  • Lubricate and adjust clutch
  • Replace spark plugs
  • Inspect brake pad linings and discs for wear
  • Inspect oil lines and brake system for leaks
  • Check, adjust the operation of enrichener, throttle control
  • Inspect fuel valve, lines and fittings for leaks
  • Check operation of all electrical equipment, switches & lighting
  • Check battery and clean connections
  • Check tire pressure and inspect thread
  • Road test

 

SPECIALISING IN HARLEY DAVIDSON® REPAIRS, MODIFICATIONS & SERVICING

All work is GUARANTEED and performed by QUALIFIED specialist tradesman

Established 1998
JOE SILVESTRI
Certified Automotive Engineer

MAJOR SERVICE - $550

  • Replace engine oil & filter
  • Inspect air cleaner, service as required
  • Replace primary chain case lube & clean drain plug
  • Check & adjust the rear belt tension & alignment
  • Adjust primary chain & check tension/wear
  • Clutch adjustment & lube cable
  • Replace transmission oil
  • Inspect brake pad linings & disc for wear
  • Check brake fluid reservoir levels & condition of fluid
  • Inspect oil lines & brake system for leaks
  • Lubricate front brake hand lever, throttle control cables, clutch control cables (& hand lever) rear brake pedal bushing (if applicable) lubricate all pivot points
  • Check steering head bearings & adjust if required
  • Check, adjust operation of enrichener, throttle control (early models)
  • Inspect fuel valve, lines & fittings for leaks
  • Check operation of all electrical equipment & switches
  • Check battery & clean connections – Check charge rate
  • Replace spark plugs
  • Check tire pressure & inspect tread
  • Check wheel spoke tightness
  • Lubricate hinges, latches – fuel door, tour-pak, saddlebags
  • Check tightness of all critical fasteners: hand controls, brake system, axle nuts, front fork components, riser and handlebar fasteners
  • Check engine idle speed
  • Road test

 

  • If applicable extras at charge
    • Carry out ABS service & check for any fault codes
    • XG 500 & VRSC – 24,000kms & 48,000km – Valve lash adjustment